PDF
Dynamic Braking Resistors

This article is about Dynamic Braking Resistors, and you also can know the details of how dynamic braking resistors work. If you want to get more information about these products please contact us.

How dynamic braking resistors work?
State of the art AC Variable Frequency Drives (VFD) are commonplace today, creating the need for reliable, proven Dynamic Braking Resistors that can be delivered quickly, completely assembled, and ready for convenient installation at the job-site. Dynamic Braking Resistors are used with AC VFD's to produce a braking torque in the motor during overhauling conditions. The dynamic braking resistor is connected across the DC bus and will see voltages as high as 800 volts.

The drive manufacturer normally determines the power rating (watts) needed to prevent overheating during braking duty. The peak braking current is determined by the specified resistance value. Each drive manufacturer specifies a resistance range with a minimum to prevent overcurrent and damage to the drive and a maximum value to give adequate lower dissipation capability.

A three-phase variable frequency drive (VFD) consists of three basic components - rectifier, DC line, and inverter - and a control system to manage these three components as illustrated. The rectifier converts the three-phase 60Hz AC input to a DC signal.

Depending on the system, an inductor, a capacitor, or combination of these components smoothes the DC signal (reduces voltage ripple) in the DC link part of the VFD. The inverter circuit converts the DC signal into a variable frequency AC voltage to control the speed of the induction motor.

During braking, the VFD ramps the frequency to zero. The rotational energy of the motor and load are driven back through the inverter to the DC bus.

Ohms are determined by the drive manufacturer and are usually stated as a range or minimum.

Watts are stated as either a maximum braking power or continuous braking power. In either case, the wattage rating of the resistor is calculated by the braking cycle.

Braking cycle is usually stated as a percentage; however, the actual times on and off can be used to offer the optional resistor package while minimizing size and cost.


Relative Articles:
Railroad insulators
Pollution, Creepage Distance, porcelain or Composite Insulators
Baroda bushing & insulator
High voltage pin insulator drawings and specifications
Spool insulator drawings and specifications

Orient is an international line post insulator manufacturer and supplier of high quality porcelain line post insulators and porcelain pin post insulator.
Copyright ©Zhengzhou Orient Power Co., Ltd. All Rights Reserved.     sales@orientinsulators.com     Tel: +86 13673997131